Explanation: If there is no power, check the fuse, power supply, or internal fuses. Check any external switches or isolation points.
Explanation: The frost protection feature typically activates when the ambient temperature drops to around 5°C to prevent freezing. If the temperature is higher and frost protection is engaged, it could indicate a faulty frost stat.
Do you want to check the frost stat for faults?
1. Use a thermometer to check the ambient temperature around the boiler.
2. Verify that the frost stat activates when the temperature drops below 5°C.
3. If the frost stat engages at higher temperatures, it may need replacing.
Explanation: Low pressure protection activates when the system pressure drops below 0.5-1 bar, depending on the boiler model, to prevent boiler operation under unsafe conditions.
Do you want to check the low-pressure protection system?
1. Check the boiler's pressure gauge to ensure it's reading between 1-1.5 bar.
2. If the pressure is below the safe threshold (0.5-1 bar), the low pressure protection will prevent boiler operation.
3. Refill the system to the recommended pressure using the filling loop.
4. If the system continues to lose pressure, investigate for leaks or faulty expansion vessels.
Explanation: Overheat protection prevents the boiler from operating if it exceeds a safe temperature. Most boilers have an overheat thermostat that triggers at temperatures above 95-105°C.
Do you want to check the overheat protection system?
1. Ensure the overheat thermostat is correctly installed and not damaged.
2. Use a multimeter to check the continuity of the overheat thermostat.
3. If the boiler shuts down due to high temperature, check if the overheat thermostat is triggered at temperatures above 95-105°C.
4. If faulty, replace the overheat thermostat.
Explanation: If yes, check the switch used to detect demand for hot water. This could be a flow switch or diaphragm switch. Here’s how to test it: [Instructions]
Explanation: If there’s no demand for either, the issue could be with the external controls or thermostat. Investigate these further.
Explanation: The diverter valve directs the water flow between central heating and hot water. Here's how to test it: [Instructions]
Explanation: The thermistor monitors the temperature of the water. Here's how to test it: [Instructions]
Explanation: The overheat protection system ensures the boiler doesn’t overheat. Here's how to test it: [Instructions]