INTERACTIVE EXPLORER

The switched fused spur

Rotate the reference component, inspect its labels and compare example equipment positions.

MK LOGIC PLUS · K330 WHI
Preparing the 3D model…
INSTALLED VIEW86 × 86 mm reference faceplate

Drag to rotate · scroll or pinch to zoom.
Keyboard: arrows rotate · +/− zoom · Home resets.

A reference-based teaching model. The accessory is reconstructed from MK’s published drawings. Small contours and hidden depths are approximations; the back box is an example. Removing parts here is a virtual inspection, not a guide to opening an installed unit.

COMPONENT AND PLACEMENT

What the explorer shows

The component view identifies the faceplate, switch, fuse carrier, rear housing, terminals and back box. The system views compare the equipment around it. S-plan and Y-plan change the valve/control arrangement; they are not additional boiler types.

Physical positions are examples, not prescribed locations or clearances. A real installation’s equipment instructions determine supply, isolation and control requirements. The cylinder’s immersion heater is outside these examples.

MODEL REFERENCE

MK Logic Plus K330 WHI

Bottom flex outlet, thick frontplate, no neon indicator. The identified design is taken from MK’s Logic Plus technical sheet, edition 06-02, pages 1–2, supported by Honeywell’s MK product-family information.

MK documents double-pole switching for this design. Its enclosed contact mechanism is not modelled. This explorer leaves the cartridge unnumbered. The required fuse depends on the connected equipment and its instructions.

Reference notes and modelling limits

Geometry: faceplate 86 × 86 mm and 60.3 mm fixing centres follow the MK drawing. The rear-view terminal sequence follows that specific design, not all fused connection units. Cartridge and metal-box details are illustrative. The carrier’s separated pose is an inspection arrangement, not a simulation of its worm-drive mechanism.

Heating arrangements: Resideo’s S-plan and Y-plan support examples identify the relationships between controls, motorised valves, boiler and pump. They do not prescribe a physical layout. Worcester Bosch’s boiler-type guide supports the combi/cylinder distinction and the built-in components of a system boiler. These are generic relationships; permitted valve arrangements and cylinder safety controls depend on the selected equipment instructions.

Educational scope: this explorer shows components and example equipment relationships. Its amber paths are not conductor diagrams, hydraulic designs or installation instructions. It does not establish a fuse rating, an isolation test or a suitable circuit for a property. Electrical work requires appropriate competence.

Author: Martin Smith, EPHG Limited. Martin is a qualified gas engineer and plumber, with electrical training covering central-heating systems from the switched spur onwards. This teaching model uses AI-assisted modelling and development; no independent technical review is claimed.